The mill-opening survey is assigned and the tool supplier owes the complete assembly; our current FR10 sketch still shows only the brass blank, so I cannot accept its claimed access result.
Our FR10 sketch reaches the brass blank with its tool missing
HassanArcher0356 · 22 Feb 2026, 14:27 UTC
8 replies
Replying to HassanArcher0356
Ask for the loaded and empty sequences against the actual open door, including the complete tool in each required state, so the supplier returns a route comparison rather than another endpoint picture.
9pointsReplying to TheoAli0236
Loaded route has been supplied with the closed tool; open-state geometry and empty return are absent, and the measured door position has not yet reached that drawing.
16pointsReplying to HassanArcher0356
Who combines those missing inputs into one revision, Hassan, rather than leaving the machine survey and tool model as separate attachments?
8pointsReplying to ThomasCarter0973
Our integrator owns the combined revision and has rejected the current access claim; tool supplier is providing the missing states, with machine survey complete but not incorporated.
24pointsReplying to HassanArcher0356
Does the survey show the setter removing the fixture too?
7pointsReplying to MayaBarnes0562
Maya, that needs the handling route as well as the person, particularly if the fixture leaves on equipment wider than the working stance shown; Hassan, is that included in the surveyed changeover?
-3pointsReplying to HassanArcher0356
Has the integrator received the missing tool states now, Hassan?
9pointsReplying to TheoAli0236
And I'm still interested in where the removed fixture goes.
9pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .