Our rotated dispatch cartons fit the pallet outline, but their preferred support edges cross the lower layer's gaps. The tool supplier has shown finger access only from above. I need both questions on the same review drawing
FR10 layer pattern with unshown carton bearing areas
ChloeBell0657 · 12 Dec 2025, 10:21 UTC
1 reply
Replying to ChloeBell0657
Can packaging mark the actual filled carton's required bearing areas on a section through both layers and the pallet, with tooling adding the finger opening and withdrawal route against that same revision?
8pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .