Packaging has marked the required bearing strips on our actual packed case. Tooling's FR5 picture stops at placement, with fingers closed, and the proposed turned case bridges a lower-layer gap. I want the release and withdrawal on the same section before either picture becomes an approval.
Our FR5 support sketch stops just before the fingers open
GabrielBrown0888 · 18 Mar 2026, 21:11 UTC
2 replies
Replying to GabrielBrown0888
Ask the integrator for that combined view through the full placement sequence, using the same case construction and lower layer. Two separate sketches can hide the support that the fingers need to pass through.
17pointsReplying to AnilArcher0375
Combined review rejects the turned position. The finger exit uses space under a required bearing strip. Packaging and tooling are comparing an unturned alternative with the ordinary order endings included; no replacement accepted yet.
19pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .