I can't tell whether our hand-loaded cylindrical spacer blanks differ or seat differently because the sheet only records how far they stick out; this is preparation for an FR5 loading proposal, with automatic loading still unauthorised, and I need a check the people preparing stock can actually repeat.
My chuck-loading sheet measures projection but leaves the blank itself out
NathanBaker0460 · 16 Aug 2026, 21:45 UTC
2 replies
Replying to NathanBaker0460
Measure identified blank lengths too, then compare repeated seating of one blank under the approved setup procedure.
22pointsReplying to VictorAbbott0011
I've asked quality to pair blank length with projection and retain each repeat, not just the range; that should separate between-blank variation from repeat seating variation without asking the operator to guess which one they're seeing.
9pointsAdd to the discussion
Welcome to Application Robot
By creating an account, you agree to our Terms and Conditions and community guidelines. Read our Privacy Policy for how your information is handled.