I'm reviewing a UR5e bracket proposal with good restrained checks and bad released readings, but the old correction note says almost nothing. How do I establish which measurements belong to the same part?
Can I match these bracket readings before changing the fixture?
MayaAdams0127 · 24 May 2025, 13:45 UTC
1 reply
Replying to MayaAdams0127
Start with the traveller and individual part IDs, then the drawing and fixture revisions. If the sheets only share a batch number, keep that limit visible rather than pairing readings by page order.
25pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .