I asked for the complete tool on our cylindrical-aluminium-blank layout and got a circle around the grip point, which does not show whether the body clears the open machine door. Has anyone found a simple way to make this omission obvious at a design meeting?
our FR5 sketch stops at the chuck
ZaraBaker0482 · 26 Sept 2025, 03:37 UTC
4 replies
Replying to ZaraBaker0482
Put the proposed gripper outline over it, at the same scale. A circle hides too much.
11pointsReplying to JamieCarter0991
The supplier has two gripper options but only one tool outline, and it is not labelled, so I can't do an honest overlay until they identify which one it represents.
12pointsReplying to ZaraBaker0482
Use the meeting to settle that. Otherwise everyone will approve their favourite imaginary gripper.
5pointsReplying to JamieCarter0991
I've made that the first question and asked for the open-door outline on the same drawing; I'll report back if either option survives the comparison.
23pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .