Our FR10 fixture proposal copies an old adjustment, but the records only explain alignment while clamped; how can I prepare an operator handover when the failed loose-part height check has no recorded method?
I can't accept this bracket handover without the loose-part check
SamBarnes0594 · 29 May 2025, 22:44 UTC
4 replies
Replying to SamBarnes0594
Get quality to define the finished-part check and ask whoever used the old fixture what they actually did after release. You'll need that space and responsibility in the handover too, especially if the old process included another operation nobody has put in the new layout.
14pointsReplying to SofiaBell0630
Quality is documenting the current drawing check, and the old operator remembers a separate correction bench; its purpose and time are still missing from the proposal.
4pointsReplying to SamBarnes0594
Then leave room for that question in the layout review. I'd be wary of promising a smaller footprint just because an unexplained bench has vanished from the new drawing.
10pointsReplying to SamBarnes0594
Our bracket folder had fit-up ticks mixed with loose-part measurements; check what that correction bench was meant to change before assuming it served the failed height check.
-2pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .