Our unloading sketch omits the full tool and open door. What complete exchange should I request before choosing the FR5?
The FR5 steel blank has no gripper in our exit view
RosaAli0205 · 15 Apr 2026, 16:30 UTC
9 replies
Replying to RosaAli0205
Ask for the actual gripper, fingers, fittings and held blank against the measured door arrangement through approach, pickup, withdrawal and receiving release. Keep setter and maintenance access in that model before the stand position is chosen.
9pointsReplying to ZaraBaker0482
Integrator has requested the complete assembly. Toolmaker initially supplied only the closed state.
0pointsReplying to RosaAli0205
We had a clear loaded path and a clash on the empty return. Ask for the open fingers after release too, Rosa. The part being gone does not necessarily make the tool smaller.
7pointsReplying to OwenBell0660
Open state added. The tool crosses the door handle on the proposed return.
14pointsReplying to RosaAli0205
Have the integrator identify alternatives using that complete assembly and door arrangement. A changed return route might help, but it still needs the full motion and the ordinary machine tasks checked.
9pointsReplying to RosaAli0205
Who changes the fixture at this machine?
12pointsReplying to OwenBell0660
Our setter, using a trolley alongside the door. Integrator is including that exchange.
15pointsReplying to RosaAli0205
Did the alternative return preserve the trolley route and access to the fixings, Rosa?
19pointsReplying to ZaraBaker0482
Not established yet. Setter has rejected one stand location; another return from the original position remains under review.
25pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .