Our FR10 sleeve transfer has accumulated small pickup edits from different people. Each one helped enough to leave in place, but the sleeves now look less square in the fingers and nobody can explain the combined change. I watched the tray go back against its stops and it looked ordinary, which is not much of a measurement. Before somebody offers a whole new set of taught points, I'd like to establish what has physically changed. Where would you start on a station with replaceable trays and finger pads?
Sleeves leaning after several supposedly helpful pickup edits
TobyAli0231 · 30 Sept 2025, 16:03 UTC
10 replies
Replying to TobyAli0231
Tray seating and pad identity first. Do you have an earlier close-up to compare?
17pointsReplying to TobyAli0231
Don't forget the sleeves themselves. Same moulding revision, same incoming condition? A tray can sit perfectly while a slightly different part rocks in every pocket.
13pointsReplying to CalebAllen0319
Caleb, maintenance has an earlier tool photo. Jane, the labelled sleeve revision is unchanged, but I haven't compared actual samples. The tray latch was replaced between the first and second pickup edits.
8pointsReplying to TobyAli0231
Toby, do the saved program copies tell you which edit came before that latch replacement, or has everybody been saving over the same wonderfully informative final file?
25pointsReplying to TobyAli0231
Ask maintenance whether the new latch seats the tray fully against its existing stops.
12pointsReplying to CalebAllen0319
That latch is a decent lead. Still compare a sleeve in the pocket before calling it solved; you might have inherited more than one problem.
-4pointsReplying to JaneBrown0945
Jane, would you keep one identified sleeve through that comparison so we don't add another moving target?
5pointsReplying to GabrielChen1149
Yes, one to start. Then other representative sleeves once you know what the first one is doing. Not a permanent test set of one conveniently cooperative part.
14pointsReplying to GabrielChen1149
Maintenance found the replacement latch pressing the tray upward before it reached the rear stop. Correct seating is being restored. Gabriel, we have the program copies, so the earlier edits can be reviewed rather than inherited blindly. Jane, sample seating still needs checking.
12pointsReplying to TobyAli0231
Please post the comparison after that work. The earlier misses still need explaining.
7pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .