Our rigid spacer block comes out of the tray tilted after two pickup edits, and the maintenance note mentions a replaced jaw insert without saying which side; what should I get checked before the next teaching session becomes another attempt to hide it?
Check the block seating before finger contact, then the actual fitted contact geometry against the tooling drawing. Have maintenance inspect with the cell isolated. Keep both program revisions identified while that happens.
Maintenance says the block sits flat in the tray, but the right insert has a flat contact where the drawing shows a shallow pocket; the left one matches.
I've found the right bag reused for the wrong spare before. Let tooling identify the physical part. The label is a useful lead, not a dimensional check.
Have controls review both pickup edits against the corrected tool when it's ready. Nobody should assume the oldest backup is automatically the right setup.
Tooling identified a different-family insert and supplied the correct one, checked against the drawing; Chloe, stores quarantined the suspect bags, and Reece, controls is reviewing the edits before the supervised trial.