I can follow the polymer blank into the machine on our FR10 sketch, but there is nothing holding it and the open door isn't shown. I want to get the tool and the setter into the same review before anyone settles the base position.
Use the complete tool assembly with the held blank and required finger movement against a surveyed opening and door, including the setter's changeover route; the entire approach and withdrawal need review, not only the fixture endpoint.
Identify both complete candidate assemblies in the comparison until one is selected, with their load and access assumptions stated; do not draw one adapter while pricing the other.
Thanks Isabel. Both are listed separately now. The machine owner found an inside handle absent from our original door outline, so the old apparent gap is no longer a useful comparison.
Have the integrator compare both candidates against that corrected survey, retaining empty return and service access; the handle change should remain visible in the revision notes.
Requested, with the setter's route carried over. Neither candidate is accepted yet. We finally have one review request instead of three people drawing their own version of the opening.
Who will keep the selected assembly and machine survey together in the eventual handover, so later tool replacements do not fall back on the superseded clearance view?