Our shipping-carton layer rotates preferred bearing areas above gaps. I want packaging and tooling reviewing the same FR10 arrangement, including the last cartons. Which combined view should start that discussion?
What view joins our FR10 carton bearing areas to the finger exit?
HenryBennett0699 · 20 Jun 2026, 12:27 UTC
3 replies
Replying to HenryBennett0699
Show the packed carton's required support over the layer below and pallet, then the tool placing, opening and withdrawing beside existing cartons; one common revision should also state allowed partial loads and dispatch conditions.
8pointsReplying to HenryBrown0873
Packaging has the bearing sketch, while tooling's drawing stops at the carton outline. I've requested their shared view and included the partial-load question. No pattern accepted yet.
11pointsReplying to HenryBennett0699
Has either owner identified a limiting position now, Henry? The shared view will be useful only if their actual findings and remaining questions stay beside it.
4pointsAdd to the discussion
Welcome to Application Robot
By creating an account, you agree to our Terms and Conditions and community guidelines. Read our Privacy Policy for how your information is handled.