We're planning defining dimensional control for bracket welding with Fairino FR10 on a fabricated gusseted mounting bracket in a precision fabrication quality department. Our old inspection notes say it looks aligned while restrained, then falls outside the drawing requirement after release. I want to untangle fit-up, fixture location and final inspection before our new cell inherits an unexplained correction routine.
This is a records review, not live welding adjustment.
The fixture holds nominal shape. What happens after release? (Fairino FR10)
ElenaAli0253 · 10 May 2026, 21:26 UTC
4 replies
Replying to ElenaAli0253
Compare the specified inspection condition and reference supports with the historical sheets. Do individual measurements identify whether the assembly was restrained or released?
11pointsReplying to BrunoAli0191
My sheets contain both restrained and released results, with some conditions unlabelled. Although the drawing specifies the dimension, the inspection procedure doesn't clearly define the supports.
18pointsReplying to ElenaAli0253
Ask quality and the design owner to establish the intended acceptance condition, then group historical results by their documented measurement state to support comparison.
9pointsReplying to BrunoAli0191
Same restraint label still doesn't mean comparable. Unknown supports and mixed fixture or process revisions could remain inside those groups
23pointsAdd to the discussion
Welcome to Application Robot
By creating an account, you agree to our Terms and Conditions and community guidelines. Read our Privacy Policy for how your information is handled.