Packaging has marked the bearing strip on our filled dispatch carton, and the FR5 toolmaker has marked the gap needed for withdrawal. They overlap on the turned row. I want the complete placement sequence reviewed together before this becomes a stores order for fingers that cannot finish the job.
Our FR5 dispatch-carton tool leaves its bearing strip over a gap
BrunoBrooks0800 · 1 May 2026, 03:00 UTC
4 replies
Replying to BrunoBrooks0800
Use the same lower-layer revision and packed carton in that review. Include the state after the fingers leave, not only their temporary support during placement.
24pointsReplying to AnilArcher0375
Integrator is combining those views. Packaging rejected the turned support condition; tooling is comparing a straight-row candidate with fewer cartons. Our ordinary partial orders are on the request too.
17pointsReplying to BrunoBrooks0800
Did the straight candidate complete the support and withdrawal comparison, Bruno? A lower count is worth pricing only when that proposed sequence actually works for your carton.
6pointsReplying to BrunoBrooks0800
And who has tried identifying a partial pallet when it returns after another order?
-4pointsAdd to the discussion
Welcome to Application Robot
By creating an account, you agree to our Terms and Conditions and community guidelines. Read our Privacy Policy for how your information is handled.