简体中文界面。帖子、指南及政策正文保留原文；未对原文作自动翻译。
Toolroom machinist moving into robot fixtures
CarlaAbbott0053
Carla Abbott
Scotland加入于2025年5月1日68篇帖子
关于
Toolroom machinist moving into robot fixtures. Currently exploring vision inspection and fixtures. Working around inconsistent part presentation; planning a 9-week trial before making a decision.
Vision inspectionFixtures
参与的讨论
M1条回复O12条回复O20条回复L10条回复L10条回复C8条回复A11条回复C6条回复S10条回复
4条回复C2条回复C19条回复4条回复I20条回复E18条回复D4条回复M15条回复P13条回复4条回复C9条回复
Our monitor counts a retained PLC signal twice (Universal Robots UR5e, fixture-check bookkeeping)
What should count as dimensional acceptance after welding? (Fairino FR5)
Our faceplate scratch captions follow whichever streak the camera sees
Another bracket review cannot borrow the incoming condition missing from my old records
Fairino FR10: The fixture holds nominal shape. What happens after release?
The scratch labels look less certain than the images suggest - inspecting reflective surfaces for scratches
A robot-presented camera station: Are we teaching our camera to reject reflections?
What counts as a confirmed defect on a reflective surface? - planning camera inspection of reflective parts
our ur5e bracket estimate skips whatever happened before final acceptance
Light gripper, long bracket. Not sure my FR3 layout is an improvement
Which service intake number belongs to our returned FR10 pendant?
Are these bracket readings even measured from the same face?
FR5 vacuum tooling: move the generator off the wrist?
I cannot select inspection references from these trim-plate labels
Why does our FR10 monitor wait for a log file before asking for the next reading?
Why tune our FR5 scratch check before the trim plates are judged?
What calls the bracket routine after our FR10 inspection rejects a part?
fr5 inspection handover is mostly screenshots