I overlaid the packaging section on our FR5 pallet sketch and the carton bearing edge sits right in the proposed finger channel, so I need both reviewers looking at this together before anyone orders the tool
our fr5 cartons get support only when the fingers disappear
HassanBarnes0530 · 24 Mar 2026, 22:31 UTC
7 replies
Replying to HassanBarnes0530
Send the overlay with the filled-case identity and lower-layer revision; ask for support and complete tool withdrawal to be reviewed as one arrangement
0pointsReplying to MeiBell0690
Sent it, and found packaging used an empty case in its first explanation; the actual component load bears near the ends, not across the middle
6pointsReplying to HassanBarnes0530
Has packaging seen that actual load arrangement?
9pointsReplying to HassanBarnes0530
That changes the support question. Keep the empty-case example labelled as such so it doesn't keep returning as approval for the packed one.
0pointsReplying to RickShift
Rick, yes, the packing lead has the filled case and confirmed the load position; thanks Mei, the empty-case slide is withdrawn from this review
6pointsReplying to HassanBarnes0530
And the tool designer has the same section?
2pointsReplying to RickShift
Hassan, make the section part of the shared revision, not another loose attachment someone has to remember to open
9pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .