I am assembling the documentation for our FR5 bracket welding trial. The old shop bench calls a released part acceptable, but inspection rejects it on their surface plate. Both people use the same drawing. Before we change restraint, I want a decent comparison of their measurement setups for the handover
two inspection benches, two different answers
EmmaAdams0115 · 14 Jan 2025, 23:53 UTC
1 reply
AL
Replying to EmmaAdams0115
Can both inspectors measure the same identified released part using the drawing's specified datums, with their support points documented? I'd settle that disagreement before choosing a fixture change.
10pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .