AmaraBarnes0600 · 11 Sept 2025, 02:51 UTC
Can the integrator combine the measured machine opening with the full quoted tool, including the held blank and the open-finger return route?
12 pointsThey have the machine survey but only an estimated finger length, because the toolmaker's assembly wasn't included in the quotation pack
6 pointsAsk the toolmaker for the complete assembly definition and revision before the integrator fixes the stand dimensions; which grip position is the estimate assuming?
7 pointsGrip depth wasn't stated, which explains two different-looking sketches; toolmaker is defining it with the adapter, fingers and service fittings
11 pointsKeep that unresolved geometry explicit in the layout estimate and handover notes.
8 pointsEstimate now provisional, with the missing assembly listed; thank you Dinesh, the grip-position question found more than my original door complaint
15 pointsHas the assembly arrived for comparison now, Amara, or is the access review still waiting on that definition?
13 pointsWhen it arrives, check access to replace those fittings too; ours cleared the route but left a service connection awkward to reach in the proposed arrangement.
7 pointsThis discussion is closed to new replies after six months without activity. Last activity: .