Supplier shows the vacuum tool holding one aluminium enclosure panel. Our job starts with stacked panels and ends in an assembly fixture. Separation and support through that move are still unexplained.
Our FR5 panel quote tests a loose sheet, not the incoming stack
AmaraAllen0339 · 11 Apr 2026, 02:37 UTC
6 replies
Replying to AmaraAllen0339
Give the supplier representative incoming stacks and the receiving fixture details, then ask for the proposed separation, support and single-panel confirmation through the complete sequence, including how a suspected double is handled.
23pointsReplying to JamieBarnes0556
Stacks have protective film on alternate faces. Their test sheet had no film. I have added that difference to the sample request.
17pointsReplying to AmaraAllen0339
Does anyone remove that film before this operation?
14pointsReplying to ChloeBarnes0570
No. It stays until the next assembly stage. The proposal must handle panels in that incoming condition.
9pointsReplying to AmaraAllen0339
Then ask them to demonstrate that actual condition through release into the fixture, not infer it from a bare-sheet seal, with the panel support and any manual separation work visible.
24pointsReplying to JamieBarnes0556
Who clears a suspected double, and can they reach the stack without dismantling the tool?
-1pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .