I watched our sleeve pickup closely after the latest point adjustment. The sleeve is upright in the tray, then leans before the second finger reaches it. We have saved several versions of the job, each claiming to improve pickup. I would like the tool checked before we create another improved version.
FR5 sleeve starts leaning after the first finger touches
ClaraBrooks0785 · 11 Mar 2026, 20:40 UTC
7 replies
Replying to ClaraBrooks0785
Compare both fitted contact positions with the intended assembly, Clara, including backing pieces and mounting; ours tipped because a replacement contact sat proud, but your observed timing needs its own inspection.
15pointsReplying to SaraAllen0287
Maintenance found the first finger's contact pad loose on its backing. It shifts under light inspection pressure while the other stays fixed. The mounting below the finger is sound.
10pointsReplying to ClaraBrooks0785
Has the pad repair been completed and checked now, Clara, and has the integrator reviewed the saved pickup changes against that physical finding?
10pointsReplying to SaraAllen0287
Matched replacement pads fitted and checked. The integrator reviewed the edits, retaining the legitimate tray change and removing compensation linked to the loose pad. Supervised checks with the identified sleeve range showed no lean through pickup.
8pointsReplying to ClaraBrooks0785
Did those checks go through placement and release into the receiving fixture too?
18pointsReplying to SaraAllen0287
Yes, the same sample set through the complete transfer. Placement and release accepted by the application owner and quality. The loose-pad issue is closed, with the inspection point added to maintenance.
2pointsReplying to ClaraBrooks0785
Thanks for the complete result; different cause from ours, and a better handover than another unexplained pickup offset.
18pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .