GabrielChan1062 · 25 May 2025, 06:54 UTC
A view from underneath the rotated case helped us see what the top view hid, though your packing person needs to mark where this particular case carries its load
14 pointsThank you. We only have the outside dimensions so far. I'll ask packing to mark the support areas over the actual lower layer.
17 pointsAnd include whatever packing is inside it, ours looked like an ordinary box until we noticed the little divider feet doing the work
13 pointsWho supplied the support requirement? I would check it belongs to your packed case before you redesign the pattern around somebody's general carton advice.
5 pointsYes, where did those notes come from?
13 pointsOur case review also needed the tool open, not just gripping a box. The spaces between cases were there to let fingers out, which made the support question harder to solve by simply closing the gaps.
21 pointsAre you using side fingers too, Gabriel?
20 pointsYes, side fingers. The notes are from our packing designer for this case and contents. She's now got the layout and both tool positions.
16 pointsMake sure she gets any revised gaps too, otherwise the drawing she approves may already be out of date
5 pointsWe have one shared revision for the review now. Still waiting for her answer on the rotated layer. And I meant both jaw positions earlier, not two alternative tools.
12 pointsGot you, open and closed; post what she comes back with, interested whether there's room to keep that pattern
14 pointsThis discussion is closed to new replies after six months without activity. Last activity: .