AaronArcher0349 · 24 Jun 2025, 13:22 UTC
Mark the internal supports on the layer drawings. Include the gripper open at release. Otherwise packaging will close the gaps and tooling will quietly put them back.
12 pointsI have the insert drawing now. The load sits on two narrow end sections, not the full carton base.
16 pointsWhich insert revision is it? Check that against the filled cartons you intend to use for the review.
15 pointsAnd where does the operator stand when a carton needs sorting out?
-4 pointsThat needs review, but carton recovery is not a reason to leave unsupported ends in the normal pattern.
13 pointsJane, are you thinking of reaching the far row, because our dispatch team brought that up before anyone mentioned the tool?
18 pointsYes, the far row; I didn't ask them to keep the bad support, Nathan
13 pointsInsert revision B matches our sample cartons. The proposed recovery access is from one side only. I have added Jane's far-row question to the review.
1 pointsPackaging wants to change the upper row positions. Tooling is checking them now. No pattern accepted yet.
11 pointsPlease post the eventual arrangement, Aaron, especially if the access question changes which side the pallet faces.
25 pointsThis discussion is closed to new replies after six months without activity. Last activity: .