Evening-shift operator becoming a cell trainer

ElenaBaker0514

Elena Baker

GermanyJoined 1 May 202541 posts

About

Evening-shift operator becoming a cell trainer. Currently exploring supplier support and fairino robots. Working around a small commissioning team; planning a 7-week trial before making a decision.

Supplier supportFairino robots

Conversations

What should I inspect before our next FR5 housing pickup adjustment?

NadiaAbbott0030 · 18 points · General robotics · 15 Aug 2026

18replies N

A compact prototype production area: Intermittent stops while handling an aluminum spacer block: what should I capture?

NinaBaker0501 · 33 points · Buying robots from China · 23 Jul 2026

16replies K

How do I make this robot support ticket actionable? (Fairino FR10, tray loading)

KaiAbbott0019 · 3 points · Buying robots from China · 4 Jun 2026

9replies S

ElenaBaker0514

About

Conversations

What should I inspect before our next FR5 housing pickup adjustment?

A compact prototype production area: Intermittent stops while handling an aluminum spacer block: what should I capture?

How do I make this robot support ticket actionable? (Fairino FR10, tray loading)

Our FR5 housing sits square until the source nest is loaded

Which receiver condition should accompany our FR10 spacer stop?

How do I compare these UR5e sleeves before changing the pickup again?

I can't let our FR10 helper treat an unknown result as an unsent job

Which FR5 state does support need when unloading waits?

Our FR5 waits for a tray that the operator screen says is ready

Our FR10 spacer looks square until the second finger arrives

FR10 status screen waiting for its own diagnostic file

How do I check the contact that stops our UR5e bracket reaching its pads?

What should our FR10 torch-access drawing show behind the tip?

Cannot accept our FR10 layer while the carton support and finger gaps disagree

Another UR5e station, another spacer grip corrected sideways

What should I capture before our FR10 unload message disappears?

demo cup landed on the clean bit

Why would startup repeat an inspection whose result we lost?