CarlaChan1097

Carla Chan

New Zealand加入于2025年11月27日74篇帖子

关于

Independent machine-safety validation engineer. Currently exploring plc integration and palletising. Working around tight tooling clearance; planning a 10-week trial before making a decision.

PLC integrationPalletising

参与的讨论

Why does our UR5e handover show a fixture the installed plate routine no longer uses?

CarlaChan1097 · 28 分 · 机器人综合讨论 · 2026年1月17日

1条回复 C

Why does the FR10 pattern review stop before the last incomplete layer?

CarlaChan1097 · 17 分 · 应用与集成 · 2026年1月12日

12条回复 T

Cannot choose our FR10 pallet tool while the turned-case support is unresolved

TheoCarter1019 · 11 分 · 应用与集成 · 2026年1月6日

16条回复 C

Why does our FR10 pendant guide show the connector on another assembly?

CarlaChan1097 · 26 分 · 从中国采购机器人 · 2025年12月31日

19条回复 C

Why does our UR5e layer review still stop above the supporting cartons?

CarlaChan1097 · 27 分 · 应用与集成 · 2025年12月22日

1条回复 C

Why clamp our UR5e sensor bracket harder when its base is not seated?

CarlaChan1097 · 31 分 · 应用与集成 · 2025年12月20日

1条回复 C

Why is our FR10 rotated layer approved without showing what is underneath?

CarlaChan1097 · 5 分 · 应用与集成 · 2025年12月12日

0条回复 S

UR5e housing offers with no weight for the assembly doing the holding

SofiaBrooks0804 · 9 分 · 购买建议 · 2025年11月24日

19条回复

CarlaChan1097

关于

参与的讨论

Why is switch it on the answer to our damaged FR5 controller delivery?

Our steel bush blanks have two exposed lengths

Why is our FR10 pattern approved only as a finished picture?

Connector inserts that fit the wrong way round

Why does our FR5 support answer cover full layers but not the final short row?

Our FR5 support section improves while its finger exit disappears

Why is support treating our FR10 sleeve wait as an empty source tray?

Why does our UR5e handover show a fixture the installed plate routine no longer uses?

Why does the FR10 pattern review stop before the last incomplete layer?

Cannot choose our FR10 pallet tool while the turned-case support is unresolved

Why does our FR10 pendant guide show the connector on another assembly?

Why does our UR5e layer review still stop above the supporting cartons?

Why clamp our UR5e sensor bracket harder when its base is not seated?

Why is our FR10 rotated layer approved without showing what is underneath?

UR5e housing offers with no weight for the assembly doing the holding