ChloeBaker0483 · 24 Sept 2025, 17:46 UTC
Can the bezel actually move between those edges when fitted?
21 pointsYes, there's play in the temporary holder. I can seat it against either edge before the photograph. The folder doesn't say which edge was used.
13 pointsHave tooling check the intended location before you collect another reference set.
9 pointsWho decided the part was accepted? I only ask because we once kept repeating somebody's first label after the sample had picked up a fresh mark. The same object isn't necessarily in the same condition forever.
5 pointsQuality checked it again, Rachel. Still accepted. They've identified a separate nicked bezel for comparison and marked the nick location on an annotated copy.
18 pointsUse the accepted and nicked parts through the same lighting comparison once the seating is repeatable, because fixing the holder alone may not make the actual defect visible
14 pointsAnd retain the old views as examples of the seating problem, clearly labelled.
6 pointsHolder revision is proposed, not built yet. Sara, old views are in a separate diagnostic folder. Rebecca, the comparison request includes both physical samples and the intended camera setup.
8 pointsAsk for repeat seating by the person who will load it as well, so the comparison does not depend on the tool designer gently settling each bezel by hand.
23 pointsAdded that, Nora. And thanks Rachel for asking about the actual part; quality now owns the sample checks, instead of the folder label doing all the work.
0 pointsHas the holder been made yet?
7 pointsThis discussion is closed to new replies after six months without activity. Last activity: .