I followed an old bracket through our inspection notes while preparing the UR5e fixture study. It looked aligned in the welding fixture, failed after release, then acquired a final pass. Between the last two sheets somebody wrote corrected, with no description.
I'm not trying to change the welding process from a forum answer. I need a sensible labour allowance and a clear account of which dimension was checked. Where would you start untangling this?
Bracket correction hidden between two inspection sheets
NinaCarter1023 · 6 Apr 2026, 16:15 UTC
2 replies
Replying to NinaCarter1023
Do both sheets measure the same feature from the same drawing revision?
13pointsReplying to SamCarter1029
No. Quality found that the final sheet records hole spacing, while the released failure concerns face alignment. The pass doesn't answer that earlier failure. We are looking for the face reinspection before assigning correction time from this example.
8pointsDiscussion closed
This discussion is closed to new replies after six months without activity. Last activity: .