简体中文界面。帖子、指南及政策正文保留原文；未对原文作自动翻译。

应用与集成

机床上下料、焊接、码垛及末端执行器。

发起讨论

3,710个讨论

The small dispatch area's UR5e pattern needs a defined partial-load condition

GraceChen1190 · 33 分 · 应用与集成 · 2026年8月24日

10条回复 E

Why am I still maintaining this pouch-loading idea when presentation keeps changing?

EmmaAbbott0028 · 16 分 · 应用与集成 · 2026年8月23日

1条回复 J

How many of our 31 mounting plates are accepted, rather than merely counted again?

SaraBarnes0548 · 20 分 · 应用与集成 · 2026年8月23日

10条回复 H

My puck locator helped until the tray changed

Harriet_Chambers · 28 分 · 应用与集成 · 2026年8月23日

12条回复 M

my sensor brackets find different seats in the same proposed nest

MeiBrown0951 · 28 分 · 应用与集成 · 2026年8月23日

3条回复 A

How do I keep the bracket correction visible when the old readings cannot be paired?

AdaAli0216 · 35 分 · 应用与集成 · 2026年8月23日

9条回复 D

our FR10 bracket plan is inheriting an unexplained correction step

DeanChambers · 17 分 · 应用与集成 · 2026年8月23日

2条回复 A

I cannot carry an unexplained bracket correction into the UR5e plan

AlistairChambers · 28 分 · 应用与集成 · 2026年8月23日

0条回复 F

The replacement tray spoiled my claim that the puck locator was fixed

FelixBennett0719 · 36 分 · 应用与集成 · 2026年8月23日

4条回复

应用与集成

The small dispatch area's UR5e pattern needs a defined partial-load condition

Why am I still maintaining this pouch-loading idea when presentation keeps changing?

Where do our turned UR5e product boxes actually bear?

The bracket acceptance pack mixes fit-up notes with released inspection

Which view connects our FR5 dispatch-carton support to the hand leaving?

The UR5e bracket history needs more than a restrained alignment tick

my FR5 carton review needs the conditions behind each approval

How much of our bracket correction history is a measurement-setup change?

Our FR10 panel seal report never reaches the receiving support question

Which bracket condition did our old acceptance record actually describe?

our neat FR5 layer leaves product-box supports above empty space

Our turned dispatch cartons leave support gaps in the UR5e layer

Our FR5 case-support arrow needs an explanation before the layer gets signed

How many of our 31 mounting plates are accepted, rather than merely counted again?

My puck locator helped until the tray changed

my sensor brackets find different seats in the same proposed nest

How do I keep the bracket correction visible when the old readings cannot be paired?

our FR10 bracket plan is inheriting an unexplained correction step

I cannot carry an unexplained bracket correction into the UR5e plan

The replacement tray spoiled my claim that the puck locator was fixed