EmmaBennett0724

Emma Bennett

North West England加入于2025年3月19日77篇帖子

关于

Used-equipment inspection technician. Currently exploring welding cells and fixtures. Working around inconsistent part presentation; planning a 4-week trial before making a decision.

Welding cellsFixtures

参与的讨论

Our UR5e sleeve grip went crooked after the fingers were serviced

NadiaAllen0291 · 24 分 · 机器人综合讨论 · 2026年4月17日

10条回复 H

What should I report about this incomplete tray-to-tray loading improvement? (Universal Robots UR5e)

HassanChen1139 · 21 分 · 应用与集成 · 2026年4月16日

18条回复 Y

EmmaBennett0724

关于

参与的讨论

Our UR5e sleeve grip went crooked after the fingers were serviced

What should I report about this incomplete tray-to-tray loading improvement? (Universal Robots UR5e)

I can't choose another FR5 correction while the housing leans before closure

our fr5 spacer instructions end where the tutor starts guessing

Our UR5e connector stops halfway into the fixture-loading sequence

Trim-plate photos with a fixture number pretending to identify the sample

The bracket pass was measured before the clamps came off

How do I compare FR5 pads when our housing marks depend on the viewing setup?

How do I ask for the work between sealing on a panel and delivering one?

Which bracket height was checked after the clamps came off?

i did the easy part of that UR5e demo

An FR10 arm delivered against a complete-package receipt

Our bracket folder records a correction but stores has no matching gauge

Our FR10 delivery contains an arm but no controller

Three pickup edits and our FR5 still grips the puck crooked

Cannot approve the UR5e weld layout from a line through the clamps

Which inspection stage produced these accepted bracket heights?

The good bracket dimension was written after straightening

The bracket rocks until we tighten the clamp

One inspector measured the bracket while it was still clamped