Latest discussions
Questions, experiences, and practical advice from the community.
S6repliesO5repliesT10repliesH7repliesL16repliesS13repliesJ16repliesR19repliesP6repliesL19repliesF4repliesB8repliesJ14replies
4repliesR7repliesT0repliesI20repliesZ6repliesF13repliesJ18replies
Would a stronger clamp hide a locating problem? (placing drilled components in an assembly fixture)
What should my fixture-to-tray transfer review say about operator help? (Universal Robots UR5e)
My phone video hasn't been enough to diagnose this stop (Universal Robots UR5e, fixture unloading)
A small panel handling station: Fairino FR5 panel tooling: the bench seal is only part of my question
What counts as a confirmed defect on a reflective surface?
The reach sketch leaves out our machine door and gripper - machine fixture loading
Intermittent stops while handling a molded connector body: what should I capture? (fixture unloading)
Closing a missing accessory issue without overstating it (Fairino FR5, placing parts in assembly nests)
Are we teaching our camera to reject reflections? (Fairino FR5, checking cosmetic metal surfaces with a fixed camera)
An arm on a pallet isn't the complete package I ordered (Fairino FR5, placing assembly inserts)
A small parts assembly workshop: My phone video hasn't been enough to diagnose this stop
A shared tray handling station: Holding a molded plastic sleeve less squarely than before
Fairino FR10: One item, several inspections, an inflated total