简体中文界面。帖子、指南及政策正文保留原文；未对原文作自动翻译。
应用与集成
机床上下料、焊接、码垛及末端执行器。
J0条回复R20条回复M7条回复O9条回复D4条回复L6条回复H15条回复H10条回复J7条回复B6条回复E1条回复J3条回复T11条回复E7条回复L11条回复Y1条回复L8条回复
2条回复S3条回复S14条回复
Which carton support details belong on our FR10 pallet review?
One bracket, two accepted ticks
Am I carrying an old bracket correction into the wrong fixture?
rotated cartons over pallet gaps
Was the gusset bracket measured from the same face after release?
Duplicate inspection count after reconnect
our bracket checks stop before the part leaves the jig
our spacer length sheet mixes two different measurements
Can our FR5 finger channels coexist with the carton support rails?
Retained completion added again after reconnect
Our FR10 sample trial used a different tool adapter
our pallet pattern has support gaps under the heavy ends
Cannot accept the FR10 vacuum head from a plain carton sample
How did our UR5e pallet drawing get approved without the cartons?
How should I compare these brackets when nobody measured them before correction?
Pouch trial with a growing shelf of guides
Cannot approve the FR5 corner approach from a line-shaped torch