Programming & support

Work through software, SDKs, connectivity, and commissioning.

Start a discussion

2,357discussions

I cannot select our FR10 bezel references from the bright-line labels

FarahAli0243 · 28 points · Programming & support · 18 Jan 2026

9replies N

How am I supposed to approve a UR5e scratch reference when the arrow follows the light?

NoraAllen0322 · 15 points · Programming & support · 18 Jan 2026

0replies L

Can I retain these faceplate images without retaining their guessed scratch labels?

LucaBrooks0787 · 30 points · Programming & support · 17 Jan 2026

2replies E

How can I test an unavailable FR10 reading without leaving the old result on screen?

RaviAllen0302 · 17 points · Programming & support · 14 Jan 2026

1replies S

Our FR10 late result only arrives at the wrong moment by luck

SamAli0246 · 31 points · Programming & support · 14 Jan 2026

8replies A

How do I hold the old plate result until the new attempt starts?

AmaraAdams0165 · 14 points · Programming & support · 14 Jan 2026

17replies C

Our faceplate keeps its scratch while the bright stripe moves away

ChrisBowen · 21 points · Programming & support · 13 Jan 2026

10replies N

same trim plate, different seating, new 'scratch'

NoraBrown0931 · 33 points · Programming & support · 13 Jan 2026

10replies H

Which housing did this FR10 acknowledgement belong to, then?

HazelArcher0397 · 33 points · Programming & support · 13 Jan 2026

2replies J

Bezel reference views missing the inner lip

JamieAdams0121 · 18 points · Programming & support · 12 Jan 2026

21replies S

Our UR5e bush-loading plan has two incompatible ready events

SaraAbbott0026 · 6 points · Programming & support · 12 Jan 2026

15replies

Programming & support

I cannot select our FR10 bezel references from the bright-line labels

How am I supposed to approve a UR5e scratch reference when the arrow follows the light?

Can I retain these faceplate images without retaining their guessed scratch labels?

our ur5e fake says true even when the status reply is missing

How do I assign this FR5 acknowledgement when restart reused the bracket label?

Our UR5e display finds a normal status inside an unsuccessful response

Trim-plate teaching images with no parts behind the arrows

Our faceplate reference crop hides where the bright line starts

How can I replay the old plate result without depending on a slow laptop?

How do I stop our FR10 display treating a failed read as a status?

our fr10 faceplate reference has been cropped past the locating edge

Our FR5 saved pocket advances before placement is confirmed

How can I test an unavailable FR10 reading without leaving the old result on screen?

Our FR10 late result only arrives at the wrong moment by luck

How do I hold the old plate result until the new attempt starts?

Our faceplate keeps its scratch while the bright stripe moves away

same trim plate, different seating, new 'scratch'

Which housing did this FR10 acknowledgement belong to, then?

Bezel reference views missing the inner lip

Our UR5e bush-loading plan has two incompatible ready events