Packaging line changeover coordinator

HazelAli0223

Hazel Ali

MidlandsJoined 8 May 2025113 posts

About

Packaging line changeover coordinator. Currently exploring machine tending and palletising. Working around a restricted weekend trial window; planning a 7-week trial before making a decision.

Machine tendingPalletising

Conversations

Which carton drawing should own the UR5e support and release comments?

AishaCarter1040 · 15 points · Applications & integration · 17 Jun 2026

5replies S

How do I find what our old bracket correction actually corrected?

SofiaBrown0891 · 5 points · Applications & integration · 9 Jun 2026

11replies P

A small robot fixture station: The insert for a rigid connector housing looks much too easy to mix up

PriyaAdams0133 · 28 points · Applications & integration · 6 Jun 2026

14replies R

Small molded parts workshop: The tooling supplied with our Universal Robots UR5e isn't what was demonstrated

RaviAbbott0041 · 3 points · Applications & integration · 22 May 2026

9replies H

HazelAli0223

About

Conversations

Which carton drawing should own the UR5e support and release comments?

How do I find what our old bracket correction actually corrected?

A small robot fixture station: The insert for a rigid connector housing looks much too easy to mix up

Small molded parts workshop: The tooling supplied with our Universal Robots UR5e isn't what was demonstrated

Enough reach, incomplete drawing (Fairino FR10)

Checking room for the tool holding a rectangular polymer blank

Who should combine the FR5 gripper and mill-door geometry?

Why has our acceptable UR5e trim plate acquired a scratch label?

Which lower-layer revision supports our FR10 turned component cases?

Why does our FR10 layer approval use the wrong packed carton?

Who owns clearing the job handshake?

Why does our FR5 exchange drawing lose the gripper at the doorway?

I can't explain our UR5e request light when the application never sees it

The UR5e panel tool seals on a sample already lifted from the stack

Turned cartons bridging our lower-layer gaps

Which lower layer belongs under our turned FR5 cartons?

How do I stop our UR5e pickup edits hiding what makes this puck lean?

Our FR5 layer rotates the carton support away from the layer below

Our FR5 scratch examples move when the faceplate is reseated

Our FR10 layer review uses two versions of the same packed case