Independent machine-safety validation engineer

TobyAbbott0057

Toby Abbott

CanadaJoined 9 Nov 2025167 posts

About

Independent machine-safety validation engineer. Currently exploring palletising and grippers and tooling. Working around tight tooling clearance; planning a 4-week trial before making a decision.

PalletisingGrippers and tooling

Conversations

Bright streaks move when we present the part differently - planning camera inspection of reflective parts

ImranArcher0392 · 16 points · Programming & support · 4 Apr 2026

7replies J

TobyAbbott0057

About

Conversations

Bright streaks move when we present the part differently - planning camera inspection of reflective parts

Which torch assembly belongs in our UR5e inside-corner check?

Our FR5 stop clip shows an empty fixture but no release decision

Why does our FR5 brass-blank sketch stop before the open fingers leave?

does the fr10 tool fit where the polymer blank fits?

Why has our FR5 pattern gained a turn that packaging never reviewed?

Why does the FR10 pattern still turn cartons over the unsupported strips?

the demo box had a very convenient patch of bare board

Why has our FR10 order demonstration become a general workshop video?

Why does ready mean receipt to one UR5e supplier and availability to the other?

The turned cartons bear on our finger gaps

fr5 lesson pattern with nowhere for the supported carton ends to sit

Can two end stops prevent our UR5e bracket from reaching its pads?

I cannot choose our FR5 turned row just to put the carton labels outside

the ur5e plate is thicker than the assembly we ordered

How do I assess our FR5 panel pickup with two sheets stuck together?

Why is our FR10 rotated row approved before anyone checks its bearing edges?

Cannot choose our FR10 pallet tool while the turned-case support is unresolved

Why would our FR10 startup repeat a request whose outcome is unknown?

Which receipt covers our missing FR10 mounting-kit crate?