Application safety assessor
LucyCarter1002
Lucy Carter
GermanyJoined 28 Mar 2025123 posts
About
Application safety assessor. Currently exploring fixtures and spare parts. Working around limited floor space; planning a 11-week trial before making a decision.
FixturesSpare parts
Conversations
L6repliesC11repliesL4repliesL0repliesS19repliesS20repliesA1repliesL11repliesL11repliesL2repliesM19repliesD18repliesG20replies
6repliesB17repliesL21repliesL2replies
5repliesD11repliesL20replies
Our FR10 loading picture leaves the gripper outside the doorway
Cannot tell support whether our spacer stop started at the tray
How do I keep bracket correction time in our UR5e comparison?
Can I keep both panel stacks in our UR5e vacuum trial without making it vague?
Which check should define acceptance for our released gusset bracket?
Cannot cost our UR5e bracket route from the final pass sheet
Our FR10 vacuum report starts after the panel was separated
Can I use the old fixture check to explain this released bracket error?
How should I compare these brackets when nobody measured them before correction?
How do I stop unknown FR10 attempts returning to the send queue?
Which bracket measurement should our new fixture review start from?
Cannot arrange our UR5e installation with only the arm delivered
A request acknowledgement labelled loading ready
FR3 payload maths... have I counted the flange twice?
Can't choose clamp locations from corrected bracket readings
How do I stop these old clamped checks becoming our acceptance figures?
Can I use these corrected bracket readings to choose the new fixture?