Prototype machinist exploring small-batch automation

MiaCarter0992

Mia Carter

CanadaJoined 1 Oct 202596 posts

About

Prototype machinist exploring small-batch automation. Currently exploring plc integration and robot comparisons. Working around a strict maintenance budget; planning a 12-week trial before making a decision.

PLC integrationRobot comparisons

Conversations

Should startup resubmit a job with no saved result? (Fairino FR5)

MiaCarter0992 · 33 points · Programming & support · 25 May 2026

0replies M

Separating reachability from the controller service (Fairino FR5, diagnostic status collection)

MiaCarter0992 · 28 points · Fairino robots · 8 May 2026

5replies M

MiaCarter0992

About

Conversations

Should startup resubmit a job with no saved result? (Fairino FR5)

Separating reachability from the controller service (Fairino FR5, diagnostic status collection)

I cannot choose the FR10 SDK from three similarly named folders

They can start the saved job. Then something interrupts it. - tray transfer

Which fixture does this FR10 stop capture actually describe?

How do I identify the FR10 pads in this workshop-wide demonstration?

I can't accept the FR5 turned layer with unsupported carton ends

I cannot choose the next pocket after an interrupted spacer transfer

our 109 FR10 kits contain only 102 finger sets

Steel-blank tool missing from the FR10 exit view

The FR10 demo looks busy but I can't identify our pads or housings

I can't book FR10 setup from a shipping label nobody has collected

FR10 mounting crate missing behind one delivered unit

UR5e corner sketch contains a torch line and no clamp handle

Cannot choose the FR5 bracket fixture from a pass measured while clamped

Our faceplate keeps its scratch while the bright stripe moves away

How do I show that our FR5 nest has two believable seats?

FR5 carton support and withdrawal using the same gap

Why is this refurbished FR5 inspection report for another serial?

Cannot choose the UR5e panel tool from a sheet someone peeled off by hand