Quality measurement technician

ThomasBrown0886

Thomas Brown

AustraliaJoined 2 Mar 2025102 posts

About

Quality measurement technician. Currently exploring small-batch automation and welding cells. Working around remote technical support; planning a 15-week trial before making a decision.

Small-batch automationWelding cells

Conversations

Can someone receive our FR5 module without admitting it is theirs?

ThomasBrown0886 · 12 points · Buying robots from China · 17 Feb 2026

2replies T

Why does nobody know where our FR5 was handed over?

ThomasBrown0886 · 6 points · Buying robots from China · 1 Feb 2026

6replies R

Which FR5 bracket should our installer work from when the supplied one changes the tool position?

RachelBaker0522 · 3 points · Buying advice · 23 Jan 2026

20replies A

The FR10 bracket estimate gives a witness mark the weight of an inspection

AdaAdams0129 · 13 points · Applications & integration · 9 Jan 2026

12replies T

Why is a stronger clamp the answer when our FR10 bracket nest has two competing seats?

ThomasBrown0886 · 25 points · Applications & integration · 12 Dec 2025

21replies N

ThomasBrown0886

About

Conversations

Can someone receive our FR5 module without admitting it is theirs?

Why does nobody know where our FR5 was handed over?

Which FR5 bracket should our installer work from when the supplied one changes the tool position?

The FR10 bracket estimate gives a witness mark the weight of an inspection

Why is a stronger clamp the answer when our FR10 bracket nest has two competing seats?

How should our FR5 report count a bracket whose acceptance was withdrawn?

The FR5 stop is visible but our two recordings disagree

What did this refurbished FR5 inspection cover besides a power-on photo?

Where is the second parcel with our FR10 controller, then?

How is this UR5e interface equivalent to the drawing we approved?

An extra clamp justified by corrected bracket measurements

Why are we calling this an FR10 fault before checking the laptop route?

The counter congratulated us for inspecting the same plate again

I can't approve this copied bracket correction

Why are we changing controller settings before comparing the two laptops?

Which demo won, the arm or the tray?

How do I stop these old clamped checks becoming our acceptance figures?

The vacuum report tested one flat panel on a bench

Why does a reviewed retry make two accepted brackets?

Can I retire this mysterious correction tab?