ThomasBrown0886

Thomas Brown

Australia加入于2025年3月2日102篇帖子

关于

Quality measurement technician. Currently exploring small-batch automation and welding cells. Working around remote technical support; planning a 15-week trial before making a decision.

Small-batch automationWelding cells

参与的讨论

Can someone receive our FR5 module without admitting it is theirs?

ThomasBrown0886 · 12 分 · 从中国采购机器人 · 2026年2月17日

2条回复 T

Why does nobody know where our FR5 was handed over?

ThomasBrown0886 · 6 分 · 从中国采购机器人 · 2026年2月1日

6条回复 R

Which FR5 bracket should our installer work from when the supplied one changes the tool position?

RachelBaker0522 · 3 分 · 购买建议 · 2026年1月23日

20条回复 A

The FR10 bracket estimate gives a witness mark the weight of an inspection

AdaAdams0129 · 13 分 · 应用与集成 · 2026年1月9日

12条回复 T

Why is a stronger clamp the answer when our FR10 bracket nest has two competing seats?

ThomasBrown0886 · 25 分 · 应用与集成 · 2025年12月12日

21条回复 N

ThomasBrown0886

关于

参与的讨论

Can someone receive our FR5 module without admitting it is theirs?

Why does nobody know where our FR5 was handed over?

Which FR5 bracket should our installer work from when the supplied one changes the tool position?

The FR10 bracket estimate gives a witness mark the weight of an inspection

Why is a stronger clamp the answer when our FR10 bracket nest has two competing seats?

How should our FR5 report count a bracket whose acceptance was withdrawn?

The FR5 stop is visible but our two recordings disagree

What did this refurbished FR5 inspection cover besides a power-on photo?

Where is the second parcel with our FR10 controller, then?

How is this UR5e interface equivalent to the drawing we approved?

An extra clamp justified by corrected bracket measurements

Why are we calling this an FR10 fault before checking the laptop route?

The counter congratulated us for inspecting the same plate again

I can't approve this copied bracket correction

Why are we changing controller settings before comparing the two laptops?

Which demo won, the arm or the tray?

How do I stop these old clamped checks becoming our acceptance figures?

The vacuum report tested one flat panel on a bench

Why does a reviewed retry make two accepted brackets?

Can I retire this mysterious correction tab?