Open-source robotics simulation contributor

FelixBaker0458

Felix Baker

South East EnglandJoined 13 May 2025154 posts

About

Open-source robotics simulation contributor. Currently exploring plc integration and fairino robots. Working around a strict maintenance budget; planning a 9-week trial before making a decision.

PLC integrationFairino robots

Conversations

How should the FR10 check identify a cover insert after its label holder is swapped?

IslaBowen · 18 points · Applications & integration · 29 Jan 2026

4replies J

FelixBaker0458

About

Conversations

How should the FR10 check identify a cover insert after its label holder is swapped?

How does our UR5e recipe know the cover insert was turned round?

The FR5 vacuum demo missed the tape seam our cartons actually have

Cannot attach this UR5e acknowledgement to the newer housing by its timestamp

Our FR10 spare cable is listed twice and delivered once

Which bracket readings should I pair before costing our FR5 correction bench?

Our UR5e support section now leaves two quite different packing options

Which locating-block revision belongs with our FR5 bracket acceptance notes?

My FR10 pilot estimate assigned our colleague free fixture work

Can't choose our UR5e trim-plate view while the loader can't see the stop

Which ready signal acknowledges our FR5 loading request?

Can't choose a scratch threshold from these cropped cover pictures

How can I make our offline FR10 check fail usefully?

Our FR10 monitor catches up in a burst after saving a log

How did our UR5e pallet drawing get approved without the cartons?

one FR5 acknowledgement between two uses of the same job label

Why does this FR10 access check draw everything except the tool?

How should the UR5e wrapper reject an unsuccessful status response?

Crate support pushed against the FR5 tool cover

An FR10 acknowledgement with two possible attempts